• Home >
• RO Membranes >
• Filmtec Nanofiltration Membranes >
• NF270-2540

Dow Filmtec NF270-2540 Nanofiltration Membrane

850 GPD replacement nanofiltration membrane element

The Filmtec NF270 membrane elements are ideal for removing a high percentage of TOC and THM precursors with medium to high salt passage and medium hardness passage. The Filmtec NF270 membrane is an ideal choice for surface water and ground water where good organic removal is desired with partial softening. The NF270-2540 element has a tape outer wrap.

Specifications: Membrane Type: Polyamide Thin-Film Composite (TFC) Maximum Operating Temperature: 113F (45C) Maximum Operating Pressure: 600 psi (41 bar) Maximum Feed Flow Rate: 6.0 gpm (1.4 m3/hr) pH Range, Continuous Operation: 2-11*** pH Range, Short-Term Cleaning: 1-12* (30min) Maximum Feed Silt Density Index: 5 SDI Free Chlorine Tolerance: < 0.1 ppm** Permeate Flow Rate: 850 GPD (3.2 m3/day)* Stabilized Salt Rejection: >97.0%% *Permeate flow and salt rejection based on the following test conditions: 2000 ppm MgSO4, 77F (25C) and 15% recovery at 70 psi (4.8 bar). Permeate flows for individual elements may vary by -20%/+30%. **Under certain conditions, the presence of free chlorine and other oxidizing agents will cause premature membrane failure. Since oxidation damage is not covered under warranty, Dow recommends removing residual free chlorine by pretreatment prior to membrane exposure. Most RO systems have carbon pre-filters for this purpose. ***Maximum temperature for continuous operation above pH 10 is 95F (35C).

Dimensions:

A: 40.0" (1,016mm)    B: 1.19" (30mm)    C: 0.75" (19mm)    D: 2.4" (61mm)

Notice: The use of this product in and of itself does not necessarily guarantee the removal of cysts and pathogens from water. Effective cyst and pathogen reduction is dependent on the complete system design and on the operation and maintenance of the system.