We are pleased to offer a complete selection of replacement quartz sleeves for all Viqua (Trojan) UVMax ultraviolet (UV) sterilizers.

Viqua (Trojan) UVMax Model #602976 replacement sleeves are designed only for use in Viqua (Trojan) UVMax UV sterilizers. We do not recommend that you attempt to use Trojan replacement sleeves in models made by other manufacturers.

It is critical that only genuine UVMax brand original equipment sleeves be used in your system. It has come to our attention that a number of Chinese manufacturers are making knock-off replica UV sleeves. While they may physically fit in a UVMax system, they are NOT compatible. Testing of a wide range of these sleeves has shown that many do not allow a safe UV dose to pass through the sleeve and may be subject to failure.

UVMax #602976 is the sleeve for the following models:

• Viqua (Trojan) UVMax Model J
• Viqua (Trojan) UVMax Model J+
• Viqua (Trojan) UVMax Pro 30
• Viqua (Trojan) UVMax Pro 50
• Viqua UVMax Pro 24-100
• Viqua UVMax Pro 24-186

UVMax #602976 Specifications

Technical Specifications
Part #	#602976
Replace Sleeve	every 24 Months or as needed

How to change a UVMax #602976 Sleeve

1. Turn off water supply valve to UV sterilizer
2. Turn on faucet elsewhere in the home to depressurize the system
3. Disconnect your UV system from power (unplug unit)
4. Allow system to cool for 5 - 10 minutes
5. Follow instructions for removing lamp
6. Remove the top retaining nut & O-ring
7. Remove the bottom retaining nut, Spring and loosen the O-ring to drain the water
8. Remove the quartz sleeve from the UV chamber.
9. Clean the quartz sleeve with a cloth soaked in CLR, vinegar or some other mild acid and then rinse with water.
10. Re-insert the quartz sleeve with O-ring(s), Spring, and retaining nut(s).
11. Hand tighten the retaining nut(s), taking care not to over-tighten.
12. When service is complete, assemble the prerequisites in the reverse order of disassembly.
13. Turn on water supply valve
14. Check for leaks
15. Close faucet elsewhere in the home

Viqua UVMax #602976 Sleeve Reviews

There are currently no reviews for this product.
Be the first to write a review.

Viqua UVMax #602976 Sleeve Customer Questions & Answers

Question:	Does this come with the O-rings
Answer(s):	Yes, all Viqua sleeves and lamp / sleeve combos come with the necessary o-rings By HomePlus Water on Feb 15, 2024

It is critical that only genuine Viqua brand original equipment lamps be used in your system. It has come to our attention that a number of Chinese manufacturers are making knock-off replica UV lamps. While they may physically fit in a Viqua system, they are NOT compatible. Testing of a wide range of these lamps has shown that many do not provide a safe UV dose or offer protection for the stated lamp life, and in some cases have even caused the failure of the ballast/controller and melting of the lamp harness.