Viqua Lamp & Sleeve Combo Kit for UVMax Model B & B4 - #602810-101

We are pleased to offer a complete selection of replacement lamps & sleeves for all Viqua / Sterilight ultraviolet (UV) sterilizers. Viqua / Sterilight replacement lamp & sleeve combo kits are designed only for use in Viqua / Sterilight UV sterilizers.

Trojan UVMax #602810-101 is the replacement lamp & sleeve combo for the following models:

• Viqua UVMax Model B
• Viqua UVMax Model B4

Trojan UVMax #602810-101 Specifications

Technical Specifications
Part #	#602810-101
Lamp	Trojan UVMax #602804
Sleeve	Trojan UVMax #602731
Lamp Length	9.75" (25cm)
Lamp Power	27 Watts
Lamp Life	12 Months

How to change a UVMax #602804 Lamp

1. Turn off water supply valve to UV sterilizer
2. Turn on faucet elsewhere in the home to depressurize the system
3. Disconnect your UV system from power (unplug unit)
4. Allow system to cool for 5 - 10 minutes
5. Put on clean gloves
6. Remove dust cover by squeezing and lifting up
7. Lift lamp connector straight up
8. Remove UVMax #602804 lamp from system by unscrewing and lifting straight up
9. Insert new UVMax #602804 lamp into the system
10. Screw new UVMax #602804 lamp into the system
11. Push lamp connector down onto chamber
12. Attach dust cover and slide over top of chamber
13. Plug in UV system
14. System will beep
15. Hold reset button until system beeps and counter is reset to 365
16. Slowly open water supply valve to UV sterilizer
17. Check for leaks
18. Close faucet elsewhere in the home

Note: The UVMax UVMax #602804 is a fluorescent lamp and can be recycled at most hardware stores or your local hazardous waste facility.

Trojan UVMax Lamp & Sleeve Combo - #602810-101 Reviews

There are currently no reviews for this product.
Be the first to write a review.

Trojan UVMax Lamp & Sleeve Combo - #602810-101 Customer Questions & Answers

No customer questions have been submitted for this. Have a question? Ask it above.

It is critical that only genuine Viqua brand original equipment lamps be used in your system. It has come to our attention that a number of Chinese manufacturers are making knock-off replica UV lamps. While they may physically fit in a Viqua system, they are NOT compatible. Testing of a wide range of these lamps has shown that many do not provide a safe UV dose or offer protection for the stated lamp life, and in some cases have even caused the failure of the ballast/controller and melting of the lamp harness.