Vectapure V360 4 Stage Quick Change Reverse Osmosis (RO) Water Filter

Description, Features & Benefits

The Vectapure V360 quick change 4 stage reverse osmosis (RO) system is an innovative RO system designed for the ultimate ease of operation. Filter replacement can be done in literally a couple of minutes without any tools and wihout even turning the water supply off! Just a quick quarter turn to remove the old filter, and a quarter twist to lock in the new cartridge. It doesn't get any easier!

At the same time, the Vectapure V360 quick change 4 stage reverse osmosis (RO) system has all of the other features that you would expect in a quality RO system including sediment pre-filter, pre and post activated carbon filters, a thin film composite (TFC) RO membrane, chrome faucet, storage tank and complete installation kit.

For more information of the removal/reduction of various contaminants by carbon filtration and reverse osmosis, please CLICK HERE.

---

FREE BONUS: Flowlok Leak Protector

The FLOWLOK Leak Detector is an innovative device that installs right below your water filtration system in minutes. No special tools are required and it does not need electricity to operate. FLOWLOK Leak Detectors utilize a highly compressed safety disc that expands when it absorbs water. Once the safety disc has detected water it expands and trips the FLOWLOK safety lever to shut off the water entering the water filtration device. Safety discs are replaceable and are economical.

Specifications & Operating Conditions - Vectapure V360 4 Stage RO System

Stages and Specifications
Stage 1: Sediment Pre-Filter	Vectapure Blue (#V360112PP05) 5 Micron Sediment Filter Replace every 3 - 6 months - Traps silt/dust, rust and sand which may affect the taste and look of your water, while at the same time protecting the other filters from premature fouling.
Stage 2: Carbon Pre-Filter	Vectapure Green (#V360212CC05) 5 Micron Activated Carbon Cartridge Replace every 3 - 6 months - Reduces chlorine, organochlorine compounds, chlorination disinfection byproducts (THMs and HAs), many VOCs and more.
Stage 3: Reverse Osmosis Membrane	Vectapure Yellow (#V360312RO00) 75 Gallon Per Day Thin Film Composite (TFC) RO Membrane* Replace every 2-5 years - Removes 98% of most inorganic impurities.
Stage 4: Carbon Post-Filter	Vectapure Green (#V360212CC05) 5 Micron Activated Carbon Cartridge Replace every 3 - 6 months - Reduces chlorine, organochlorine compounds, chlorination disinfection byproducts (THMs and HAs), many VOCs and more.
Self-Cleaning:	This system uses a process of crossflow to constantly clean the membrane to prevent pre-mature fouling and clogging.

This system is designed for use on all chlorinated and non-chlorinated potable water supplies. It is an excellent choice for most homes. If you do not receive your water from a municipal water system (you get your water from a well, lake or other non-treated source), you should have your water tested to ensure it is biologically safe (free of bacteria, viruses, and other harmful microorganisms) before using a reverse osmosis filter as your only water treatment. If your water is biologically contaminated, you should consider a point-of-use or whole-house ultraviolet purifier in addition to your reverse osmosis unit to kill any remaining microorganisms.

* Note: While the system membrane has a manufacturer's capacity rating of 75 gallons per day, this level of production can only be achieved under what would normally be considered to be ideal (and unrealistic) conditions. In real world conditions, actual membrane production will be much lower, generally in the range of 25% to 40% of the manufacturer's membrane rating. However, the manufacturer rating is generally a good method of comparing relative membrane capacity between different RO systems.

Recommended Source Water Parameters:

Pressure: 30-100 PSI (2.1-6.9 bar)
Temperature: 39-100F (4-38C)
pH: 5-10
TDS Level: less than 2000 ppm (mg/L)
Turbidity: less than 1.0 NTU
Hardness(CaCO3):<17.5 GPG (300 mg/L)
Iron (Fe): <1 ppm (mg/L)
Residual Chlorine: <3.0 ppm (mg/L)

Note: this product is not available in the State of California. CLICK HERE for more information.

Note: The contaminants or other substances removed or reduced by this water treatment device are not necessarily present in your water.

Replacement Parts and Popular Accessories

Vectapure V360 4 Stage RO System Installation, Manuals & Resources

The filtration unit and storage tank mount under your sink, out of sight. Water supply is gained by attaching a simple adapter to your cold water supply pipe (copper or plastic). You will have to drill a hole in your countertop or sink frame to attach the faucet. It is a relatively easy do-it-yourself project, or if you prefer, you can have it installed by a handyman or plumber. The unit includes all installation hardware and a complete installation guide.
Vectapure RO Installation
and Owners Manual

Vectapure V360 4 Stage RO Quick Change RO System Model #: Vectapure V360 Reviews

There are currently no reviews for this product.
Be the first to write a review.

Vectapure V360 4 Stage RO Quick Change RO System Model #: Vectapure V360 Customer Questions & Answers

Question:	Who makes Vectapure?
Answer(s):	The Vectapure brand of water treatment systems is manufactured by Waterite Inc. By HomePlus Water on Aug 22, 2023