Carbon Block Cartridge for Watts Big Bubba® Housing
Model #: BB-C100

We are pleased to offer a complete selection of replacement cartridges for the Watts Big Bubba high flow housing. This 0.5 micron carbon block cartridge helps to reduce lead, PFOA/PFOS, cysts, chlorine taste and odor, chloramine and fine sediment. The cartridge includes a handle for easy removal and installation into the filter system. A double O-ring seal on the end of the cartridge ensures unfiltered water will not bypass the cartridge.

Features

• Chlorine and chloramine taste and odor reduction
• 0.5 Nominal micron rating
• PFOA/PFOS reduction capacity 84,480 gallons
• Lead reduction capacity 84,480 gallons

#BB-C100 Carbon Block Cartridge Specifications

Technical Specifications
Model #	#BB-C100
Order #	7100980
Media	Carbon Block
End caps	PP + FG
Center tubes	NA
Maximum flow rate (GPM)	4
Maximum temperature	125°F (52°C)
Maximum°ΔP (psi)	40
Chemical resistance	Not a factor (for water only)
Length (media)	26-1/4"
O-rings (dual)	EPDM
Shipping weight (lbs.)	20
Carton dimensions	10.75" x 10.75" x 35"
Micron rating	0.5

Note: Flow rates are based on each specific application, micron rating, solids content and a number of other factors. End user should consider these factors when selecting the filter housing (or number of filter housings) needed for their particular requirement.

How to install a Watts Jumbo Big Bubba cartridge

1. Close inlet valve.
2. Close outlet valve.
3. Open valve on drain, if a drainpipe has been installed.
4. Press pressure relief button to relieve pressure.
5. Remove lid after pressure has been relieved.
6. Rotate cartridge counterclockwise and pull upward. Remove the cartridge.
7. Install new cartridge. Push downward and rotate clockwise to engage locking tabs lubricating O-rings if necessary.
8. Check lid O-ring to ensure it is properly seated. Lubricate if necessary.
9. Replace lid.
10. Replace eyebolts and tighten. (Hand tight is sufficient.)
11. Close valve on drain if a drainpipe was installed.
12. Open outlet pipe completely.
13. Open inlet pipe slowly to check for leaks.
14. Vent filter to dispel air by depressing pressure relief button. Be careful when relieving pressure

Watts Big Bubba Carbon Block Cartridge - #BB-C100 Reviews

There are currently no reviews for this product.
Be the first to write a review.

Watts Big Bubba Carbon Block Cartridge - #BB-C100 Customer Questions & Answers

No customer questions have been submitted for this. Have a question? Ask it above.