20 Micron Melt Blown Polypropylene Sediment Cartridge for Watts Big Bubba®
Model #: BBC-150-D20 / PWWJCMB20

We are pleased to offer a complete selection of replacement cartridges for the Watts Big Bubba high flow housing. Watts Big Bubba melt blown polypropylene sediment cartridges are recommended when depth filtration is necessary for the reduction of soft particulate. PPWWJCMB20 melt blown polypropylene cartridges fit in Watts Big Bubba Filter Cartridge Housing.

Features

• Dual O-rings for superior sealing
• 20 Micron filtration rating
• Collects particles throughout the entire thickness of the filter
• Greater efficiency with more surface area

#PWWJCMB20 20 Micron Melt Blown Polypropylene Sediment Cartridge Specifications

Technical Specifications
Part #	#PWWJCMB20
Model #	#BBC-150-D20
Order #	7100310
Media	Melt Blown Polypropylene
End caps	PP + FG
Center tubes	Poly Propylene
Maximum flow rate (GPM)	100
Maximum temperature	125°F (52°C)
Maximum°ΔP (psi)	40
Chemical resistance	Excellent
Length (media)	26-1/4"
O-rings (dual)	EPDM
Shipping weight (lbs.)	5
Carton dimensions	7" x 7" x 31"
Micron rating	20

Note: Flow rates are based on each specific application, micron rating, solids content and a number of other factors. End user should consider these factors when selecting the filter housing (or number of filter housings) needed for their particular requirement.

How to install a Watts Jumbo Big Bubba cartridge

1. Close inlet valve.
2. Close outlet valve.
3. Open valve on drain, if a drainpipe has been installed.
4. Press pressure relief button to relieve pressure.
5. Remove lid after pressure has been relieved.
6. Rotate cartridge counterclockwise and pull upward. Remove the cartridge.
7. Install new cartridge. Push downward and rotate clockwise to engage locking tabs lubricating O-rings if necessary.
8. Check lid O-ring to ensure it is properly seated. Lubricate if necessary.
9. Replace lid.
10. Replace eyebolts and tighten. (Hand tight is sufficient.)
11. Close valve on drain if a drainpipe was installed.
12. Open outlet pipe completely.
13. Open inlet pipe slowly to check for leaks.
14. Vent filter to dispel air by depressing pressure relief button. Be careful when relieving pressure

Watts Big Bubba 20 Micron Melt Blown Polypropylene Cartridge - #PWWJCMB20 Reviews

There are currently no reviews for this product.
Be the first to write a review.

Watts Big Bubba 20 Micron Melt Blown Polypropylene Cartridge - #PWWJCMB20 Customer Questions & Answers

No customer questions have been submitted for this. Have a question? Ask it above.