1 Micron Pleated Polypropylene Sediment Cartridge for Watts Big Bubba®
Model #: BBC-150-P1 / PWWJCP1
Watts Big Bubba 1 Micron Pleated Polypropylene Cartridge - #PWWJCP1 | List Price: CDN$ Our Price: CDN$332.54 You save: $66.51 Write a review. Found a Lower Price? Request a Price Beat |
|
Special Order Item.
Please contact us for lead time.
- Description
- Specifications
- Related Products
- Installation / Manual
- Reviews
- FAQ
We are pleased to offer a complete selection of replacement cartridges for the Watts Big Bubba high flow housing. Watts Big Bubba pleated polypropylene sediment cartridges are ideal for more critical applications, offering greater efficiency, more surface area for greater throughput and reduced cost for whole house sediment filtration. PPWWJCP1 pleated polypropylene cartridges fit in Watts Big Bubba Filter Cartridge Housing.
Features
- Dual O-rings for superior sealing
- 1 Micron filtration rating
- Reduces extra-fine dirt, sand, sediment, silt, rust particles, scale particles
- Greater efficiency with more surface area
#PPWWJCP1 Pleated Polypropylene Sediment Cartridge Specifications
| Technical Specifications | |
|---|---|
| Part # | #PWWJCP1 |
| Model # | #BBC-150-P1 |
| Order # | 7100303 |
| Media | Pleated Polypropylene |
| End caps | PP + FG |
| Center tubes | Poly Propylene |
| Maximum flow rate (GPM) | 150 |
| Maximum temperature | 125°F (52°C) |
| Maximum°ΔP (psi) | 30 |
| Chemical resistance | Excellent |
| Length (media) | 26-1/4" |
| O-rings (dual) | EPDM |
| Shipping weight (lbs.) | 5 |
| Carton dimensions | 7" x 7" x 31" |
| Micron rating | 1 |
Note: Flow rates are based on each specific application, micron rating, solids content and a number of other factors. End user should consider these factors when
selecting the filter housing (or number of filter housings) needed for their particular requirement.
How to install a Watts Jumbo Big Bubba cartridge
- Close inlet valve.
- Close outlet valve.
- Open valve on drain, if a drainpipe has been installed.
- Press pressure relief button to relieve pressure.
- Remove lid after pressure has been relieved.
- Rotate cartridge counterclockwise and pull upward. Remove the cartridge.
- Install new cartridge. Push downward and rotate clockwise to engage locking tabs lubricating O-rings if necessary.
- Check lid O-ring to ensure it is properly seated. Lubricate if necessary.
- Replace lid.
- Replace eyebolts and tighten. (Hand tight is sufficient.)
- Close valve on drain if a drainpipe was installed.
- Open outlet pipe completely.
- Open inlet pipe slowly to check for leaks.
- Vent filter to dispel air by depressing pressure relief button. Be careful when relieving pressure
Watts Big Bubba 1 Micron Pleated Polypropylene Cartridge - #PWWJCP1 Reviews
There are currently no reviews for this product.
Be the first to write a review.
